1 Erfahrungsbericht in Deutsch für Fiberlogy PLA FiberSilk Metallic Silver

Bewertet mit 3 von 5 Sternen.

Not so easy at all

As I think, this material is quite difficult to print. I had to adjust nearly everything on my mk3s very precisely, including linear advance and extrusion multiplier, because the material swells up when it comes out of the nozzle. Due to the swelling, it is not easy, to get used to the behaviouir of the material. It stays soft for quite a while and when i printed over 215°C, every little overhang warps up. In the end, the material looks very nice, but every little imperfection moves to the foreground and destroys the effekt of the filament. The glossy surface looks nice, but every scar or zit looks on the other hand much worse. I was not able to get a satisfying print beside some small testcubes.

I'm printing with a mk3s, bst results with 210-215°C, used volumeric flow rate (11.5) but never printed slower than 30mm/s, because the velocity is necessary to handle the swelling. Fan always on, otherwise the filament stays like gum for a while and gets squished